Traceable Quality
Talk to us
Menu

Free tool

The RFID family

RFID is five technologies that share a name. Pick a band and see its wavelength to scale, where its near field ends, how far it reads, what a tag costs and what it is good for.

Frequency
Wavelength
Near field ends at
How the tag is powered
Typical read range
Tags per pass
Tag cost, roughly
Standards

Good at

    Bad at

      You've met it as

        Where the numbers come from:

        Which one for your job?

        Answer what you know. Each yes rules some of the family out. "Don't know" leaves them all in.

        Do you need to read from more than a metre away?
        Does the tag have to read through water, flesh or a wet product?
        Do you need to read many tags in one go?
        Does a phone have to read it?
        Is a battery, and replacing it, acceptable?
        Does the tag have to cost less than the item's packaging?

        Low frequency and high frequency tags sit inside the reader's magnetic field, which is why they read through water and stop at arm's length. UHF tags ride a radio wave, which is why they read across a room. Active tags carry a battery and shout on their own.

        What you’re looking at

        Every RFID tag is a chip and an antenna, and the reader is on the other end of the air. What changes between the bands is the wavelength. At 125 kHz one wave is 2.4 kilometres long, so the tag is always deep inside the reader’s near field and the two antennas behave like the halves of a transformer. That’s a magnetic link. It goes through water and flesh, and it stops a hand’s width away.

        At 866 MHz a wave is 35 centimetres, and the near field ends at 5.5 centimetres. A tag a metre away is catching a radio wave, which is what buys the range. It’s also why water and metal get in the way.

        The boundary is the wavelength divided by 2π. The explorer draws it for each band, with a hand, a carton and a pallet for scale.

        Why this series is about UHF

        Because that’s the one on the pallet. It’s the only passive tag that reads across a room. It reads hundreds at a time, and it’s the cheapest tag there is. If you’re tracking stock or cartons, it’s the default.

        The other four are for when the default fails. An animal needs a tag that reads through flesh. A customer needs to tap it with a phone. A yard is too big for any passive tag.

        What it assumes

        The ranges are typical for a fixed reader and the common tag of each band, in free air. Tag costs are rough inlay prices at volume as of 2026, in rupees, and they are the least certain thing on the page. The questionnaire is a filter: it rules bands out, and leaves the choice between what’s left to you.

        For how to pick a tag within the UHF band, see selecting a suitable RFID system, and for how far a UHF tag will read, the range calculator.

        Where the numbers come from

        Frequencies and the near-field boundary are physics. Ranges are from the standards (ISO 14443, ISO 15693, ISO 18000-63, ISO 18000-7) and from tag datasheets, listed against each band in the explorer. The UHF range is the range calculator’s planning figure for a 1 W reader (35 dBm radiated, inside India’s 2 W ERP limit), a 6 dBi antenna and an NXP UCODE 9 tag: about 11 m with 6 dB to spare. The costs for active tags and beacons are distributor list prices; the passive tag costs are estimates.