Traceable Quality
Talk to us
Menu

Free tool

Ship from, ship to

Every country opens a different slice of the UHF band at a different power. Pick where a tagged carton leaves and where it lands, and see what the tag does at each end.

The ruler is the whole UHF RFID allocation. Teal is where you ship from, amber is where it lands. The curve is the tag's antenna: how well it answers at each frequency, on the model described below.
The tag's antenna is cut for

From
To
Band
Power allowed
Radiated, EIRP
Channels
Tag off its tuning by
Chip wakes out to

Free space, and a model of tag tuning, so the ranges are for comparing the two sites, not for planning. The power difference between regions is the easy part to check against the rules; the detuning is the part to measure with your own inlay.

UHF RFID is 860 to 960 MHz, but each country opens its own slice. Power is within a decibel everywhere. The tag's tuning is what changes at the border.

What you’re looking at

UHF RFID has a hundred megahertz to play in, from 860 to 960, and no regulator opens all of it. India and Europe now share a slice: 865.6 to 867.6 MHz, in four channels of 200 kHz. India used to stop at 867, and a 2021 rule change moved it onto the European plan. The United States opens 902 to 928 and hops across it fifty channels at a time. China, Japan, Australia and Brazil each take a corner near 920.

Power is the smaller story. India and Europe both allow 2 W ERP, which is 35.15 dBm radiated. America allows 1 W into an antenna of up to 6 dBi, 36 dBm. Within a decibel, everyone shouts about as loud. The difference is that India and Europe count what leaves the antenna, so a bigger antenna means turning the reader down, while America counts what goes into it.

The tag is where borders bite. A tag antenna is cut for a frequency, and it answers best there. Move it 50 MHz away and it loses a few decibels, and each decibel is about 12% of range. That’s why “global” inlays exist: they trade a little peak gain for a flat response across the whole band.

What it assumes

Free space, the same reader and tag as the other RFID tools here (a 6 dBi circular antenna that loses 3 dB to a flat tag, a half-wave dipole tag on an NXP UCODE 9 chip, an Impinj E710 reader), with each region’s power at its legal ceiling, and the frequency at the middle of each band.

The tag’s tuning is a model, not a measurement. It keeps full gain within 8 MHz of the frequency it was cut for, loses 0.12 dB for every megahertz beyond that, and caps at 10 dB. A global inlay is treated as 1 dB down everywhere. Real inlays vary, so use the result to compare two sites, and measure your own inlay before you plan a deployment on it.

Check the current rules

India, Europe, the USA, Japan and Australia were read against the regulation itself in November 2026: G.S.R. 853(E), ETSI EN 302 208, 47 CFR 15.247, ARIB STD-T106 and T107, and the ACMA class licence. China’s power table and Brazil’s limits were not, and the page marks them. Regulators move these: India rewrote its rule in 2021, China replaced its in 2024 and closed 840 to 845 MHz, Europe added 915 to 921 MHz in 2018. Before you buy readers for a new country, read the current text, or ask the reader maker for the country variant.

For the sums behind the ranges, see the range calculator. For why a tag answers at all, see wake the tag.