Traceable Quality
Talk to us
Menu

Free tool

Barcode or RFID?

Describe the count you do and get a straight answer: which technology pays for itself here, why, and how many hours each one costs you a month.

The count

Cartons on a rack, tools in a crib, garments on a floor.

How it's handled
Can a scanner reach every label?
Does someone scan each item anyway?
Do you need to know exactly which one?
Metal or liquid?
Assumptions we started from

Aiming and scanning, label facing out. The tool adds half again when labels are out of reach. A full store count runs far slower: 209 items an hour by barcode in the University of Arkansas Bloomingdale's pilot (2009), most of it finding the item.

A handheld walked past a rack of cartons; the walking takes the time, since readers hear 50 to 1,000+ tags a second (Impinj E710 reader modes). Folded stock on a shop floor is slower: 4,767 items an hour in the Arkansas pilot, about 75 s per 100.

Paper UHF label: Indian listings run ₹5-10 (2026), more printed and encoded in small runs. On-metal and hard tags cost several times this. Get a quote.

Thermal-transfer paper label, printed in-house.

Loaded cost of a warehouse operator in India. Use your own.

Our read

    One month of counting
    BarcodeRFID
    Time per count
    Labour hours a month
    Labour cost a month
    Labels for these items, once
    Label as a share of item value

    The hours are the counting itself, in free air. Finding the misplaced ones afterwards is where RFID's real saving usually hides, and it isn't in this table.

    Four hundred cartons. Twenty minutes with a scanner, about a minute with a reader. Then the three questions that send you back to the barcode: how cheap is the item, is someone scanning anyway, and do you need to know exactly which one.

    What it’s deciding

    RFID earns its money in three situations. A scanner can’t reach the label. There are too many items to scan one at a time. Or nobody is there to scan, so a reader on a door or a shelf has to do the capturing. Each of your answers above pushes one way or the other, and the verdict is which side has more pushes. The reasons are listed so you can disagree with one.

    The barcode wins in three others. The item is cheap enough that the tag is a real share of its price. Someone already scans it for another reason. Or you need to know which unit is in which slot. A read tells you a tag is somewhere in the antenna’s zone. A scan tells you it’s the one in your hand.

    What the hours are

    Barcode time is items times seconds per scan, with half as much again when labels are out of reach. RFID time is the walk past the shelving, which the item count stands in for. Both are the count in free air, with tags that read. Finding the ones that were put back in the wrong place is where RFID usually saves the most, and it isn’t in the table because it depends on how often that happens to you.

    Where the numbers come from

    Every assumption is under “Assumptions we started from” above, with where it came from, and you can change all of them. The tag price moves the verdict most, so check it against a real quote. Readers hear anywhere from about 50 to more than 1,000 tags a second depending on mode (Impinj reader modes, as used in the range calculator). Three seconds a scan is generous to the barcode: in the University of Arkansas pilot at Bloomingdale’s, a full store count ran at 209 items an hour by barcode and 4,767 by RFID, because most of a barcode count is finding the label. The reasoning behind this page is in Where RFID earns its money. For the longer comparison, including QR and BLE, see RFID vs barcode vs QR vs BLE. For how a tag reads at all, see Wake the tag.