IoTReadyTraceable Quality
Talk to us
Talk to us
DocsHardware
Hardware
DocsHardware
On this page

Hardware

Assembling the serial traceability system

Unbox the serial traceability system, fit the base plate, mount the data logger and wire the scanner and the scale.

Overview

The following document explores the processes of unboxing and assembly of the Serial Traceability System.

Estimated Time Required for Unboxing and Assembly: 20 mins

Disclaimer: Please power on the device only after all the connections are made.

Unboxing

  • Carefully cut open the tape that covers the package.

  • Open the box and remove the foam packaging.

  • Carefully remove all the contents from the box.

  • Check the contents against the packing list.

Assembly

The assembly of the Centralized Label Management solution contains 3 main steps.

Step 1: assembling base plate

  • Hold the base pad in your hand and follow the instructions below:

    • Put the M8 bolts through the holes labeled as A in the diagram after aligning the keypad stand on the same holes.

    • Set the M6 screws through holes labeled B.

    • Make sure all the screws are fastened.

Disclaimer: Please ensure no obstructions between the plate and scale before tightening it.

Step 2: mounting the data logger

  • Note that the side with the Device ID and the QR code is Up, and the provision for the ports is Down.

  • Keep the assembly such that the front of the weighing scale and keypad faces you.

  • Take the Weighing Scale Data Logger, and ensure you are holding the equipment upright.

  • Attach the Weighing Scale Data Logger using the spring mount to the din rail by snapping it on.

Tip: The Weighing Scale Data Logger seamlessly moves up and down the length of the supporting rail.

Step 3: connecting cables

  • Connect the Weighing Scale Data Logger to the scanner using the RS232 cable.

  • Connect the Weighing Scale Data Logger to the weighing scale using the RS232 and fasten the screws.

  • Connect the DC to the USB cable for the scanner to the USB port.

  • Connect the DC to the DC cable for power to the OUT port.

  • Connect the provided 12V power supply to the Power Input port.

Powering on

  • Use the switch on the left side (facing the display) of the device to power on the device.

For any issues, please reach out to us at support@iotready.com.